TITGEMEYER Group/Language

GETO Sider Frame base assembly

This base assembly for vehicles with a maximum gross vehicle weight of between 7.5 and 26 tonnes

Quality and durabilityThe GETO Sider Frame base assembly is yet another part of TITGEMEYER'S extensive vehicle component range. This base assembly has been developed for vehicles with a maximum gross vehicle weight of between 7.5 and 26 tonnes. The base assembly's end-to-end and offset end members and the side raves all measure 150 mm in height. The side rave profiles are available with a floor recess of either 21 mm or 27 mm, with three different longitudinal member sizes. Also included in the GETO Sider Frame package is a framework assembly for the rear wheel arch cut-out which can be supplied in 1000 mm or 1250 mm lengths as needed. Once the longitudinal members and side rave profiles have been trimmed, the base assembly is installed using nothing but screws. None of the individual base assembly parts need to be welded. Fast and uncomplicated build times are therefore ensured.

Features at a glance

Base assembly is fitted with nothing but screws, every single base assembly part is pre-drilled

  • All components are made of hot-dip galvanised, high-strength S355MC fine-grain steel
  • Maximum overall length of base assembly 7950 mm
  • Overall length is variable in increments of 25 mm
  • Maximum overall width of base assembly 2480 mm
  • Three longitudinal member heights: 100, 120 and 140 mm
  • Variable spacing between longitudinal members: 700 to 880 mm
  • Side rave heights: 150 mm with 21 and 27 mm floor recesses
  • Spacing between cross-members: 500 and 625 mm possible; also adjustable in increments of 25 mm.

Adjustments in the spacing between the cross-members will need to be made by the bodybuilder  depending on the required loads.

  • Wheel arch cut-out sub-assembly supplied: in lengths of 1000 or 1250 mm
  • Assembly components such as reinforcing brackets, assembly plates as well as chassis brackets and fasteners supplied
  • Cargo control integrated into side rave in compliance with DIN EN 12640
  • Lashing bars including fixing plate and nuts with a tensile force of 2000 daN supplied as standard; lashing bars with a tensile force of 2500 daN available on request
  • Hole pattern for installing the GETO Sider and GETO Sider Alu kit supplied
  • Hole pattern for installing the door gear keepers on the GETO Megaport II flush rear door supplied

Coordinated range

GETO Sider Frame is tailored to the requirements of the bodybuilder or fleet operator and can be readily combined not just with lightweight bodywork systems  but also our sturdy GETO Sider and GETO Sider Alu curtainsider kits. Only high-strength, fine-grain steel is used in the manufacturing process. A hot-dip galvanising process ensures all components are protected against corrosion. This eliminates the need for any additional painting or coating. The side raves incorporate integrated cargo-control rings. Every GETO Sider Frame version complements the range of certified TITGEMEYER systems and improves the levels of safety and reliability in the commercial vehicle sector.


GETO Sider Frame
GETO Sider Frame Montageanleitung

back to top